18
VANQUISH MENU TREE
19
Vanquish PC SOFTWARE
The Vanquish PC Software consists of two separate applications, the Vanquish USB Tool
which allows communication between the PC and Vanquish, and the Vanquish Boot Screen
Editor which allows users to create custom boot screens that can be downloaded onto the
Vanquish via the Vanquish USB Tool.
PC Requirements:
• Windows Vista, XP or 7 Operating System
• Hardware requirements
• 900 Mhz or faster processor
• Min. 128 MB RAM
• 25 MB of available hard disk space
Software Installation
Step 1 - Vanquish PC Software Installation
1. Insert the CD into your PC or download the files from
www.PaintballSolutions.com
2. View the contents of the software files and double-click
on “VPC Setup.exe” and follow the onscreen instructions for
software installation to your PC.
Note: Do NOT open the Vanquish PC software until instructed below!
Step 2 -
Ensure marker is Safe by removing the gas source and all paintballs before proceeding with
USB connection. With the Vanquish turned OFF, remove the firing engine and loosen the
front grip screw of the Vanquish Marker to access the USB port (see page 24). Connect your
Vanquish to your PC via the USB cable that came with the marker.
Note: The battery must be connected to the Vanquish for the USB connection to work.
Step 3 – Installing USB Drivers
Access the USB port on the Vanquish Marker Circuit board and connect the board to your
computer via USB cable. If you have an active internet connection, proceed to Step (A). If
not proceed to Step (B).
A. If you have an active internet connection the drivers will automatically install. Simply allow
windows to install the drivers for you and wait for the installation to complete. Note- windows
may install several drivers. If windows does not automatically install proceed to (B) below.
B. To manually install the FTDI USB/COM/Serial drivers please proceed below to the area that
matches the Windows version you use:
Windows XP Manual Install:
1. After connecting the Vanquish to the USB port, the New Hardware Found Wizard should
appear.
2. Select the option “No, not this time” and click “Next” to continue.
3. Select “Install from a list or specific location (Advanced)” and click “Next”.
4. Under “Search for the best driver in these locations” Browse to the “USB Drivers” folder in
the Vanquish PC Software Folder then click “Next”.
5. Depending on how your system is configured windows may pop up a warning. Click “Con
tinue Anyway”.
6. Windows will then proceed to install the first set of drivers. Click “Finish” after complete.
7. After this the New Hardware Found Wizard should appear again to install the second set of