ATTENTION!! Before Installing the ADSL PCI Modem Card: It is important to verify that the ADSL data port RJ-11 jack is configured so that the center two pins, pins 2 and 3, are used for ADSL data, otherwise the ADSL PCI modem card will not make a proper connection. Your ADSL modem card features pin jumpers that enable the user to set the configuration to make the proper connection. The modem default is set to 2 and 3.
If the ADSL data port installation uses pins 1 and 4 for data, then the jumper settings on your board will need to be reconfigured. To do this, orient your board per the diagram below (the RJ-11 connector should be facing towards you) and simply lift the jumper off of the pin setting for 2 and 3, and place it onto the pin setting for 1 and 2, which your ADSL modem utilizes.