Apogee Element Series
User’s Guide
How Element Control Input Channels appear in your Recording Program:
The Analog Input Channels of Element Control allow
you to select the type of input you are using: Mic,
Instrument, or Line Level +4dBu/-10dBV.
You may activate phantom power (48V) for condenser
mics, Group (G) channels together in stereo pairs, turn
on Soft-Limit (SL), or invert the polarity (⌀) of any of
these input channels.
In your recording program, any audio track you create
can be set to record these Analog Inputs.
In this example Logic Pro X project, four audio tracks
have been created with each track set to Input 1, 2, 3,
and 4 respectively. In this way, each Element 46
interface audio Input Channel corresponds with the
four tracks created in Logic Pro X.
You can think of your audio signal as flowing from the
analog inputs of your Element interface, through the
Element Control software’s Analog Input Channels,
then into the Logic software.
Note: With the Audio Device control feature in Logic
Pro, you can see that the settings made on these Input
Channels in Element Control are matched/mirrored by
the Audio Device section of the Logic Pro X mixer
.
The audio signal then flows through these Logic tracks
until it eventually exits through the Logic Output
channels.
From there the signal flows back into the Element
Control software:
26
Apogee Element Series
User’s Guide
How Element Control Outputs work with your Recording Program:
Signal from the Stereo Output of Logic
Pro X appears in Element Control’s
Playback 1-2 channel.
This Playback 1-2 signal will flow to the
Element interface’s outputs because the
audio source for the Headphone and
Main speaker outputs is set to Playback
1-2.
In this way, the same signal is played
from all of the Element Thunderbolt
analog audio outputs.
27
Apogee Element Series
User’s Guide
How to get a separate mix to the headphones than from the speaker outputs:
To do this, you first have to create an aux mix in your Recording Program.
In Logic, create a Send to a Bus on one of your
tracks
This automatically creates an Aux track in your
Logic Pro X Mixer
-
In Pro Tools and other DAW’s you must
manually create an Aux Track
Set this Aux track to output via Playback 3-4
.
Next, go to Element Control
and click Channel View
.
Click Playback 3-4 to show that playback channel
.
28
Apogee Element Series
User’s Guide
Set the Headphones output to Playback 3-4
to send this signal to your headphones
output.
The Main monitor outputs are still set to
Playback 1-2 and play audio from Logic’s
Stereo Out master track.
29
Apogee Element Series
User’s Guide
Essentials Snapshot Template
This Snapshot Template is the same as the Getting Started Snapshot Template but only the Essentials Window is displayed.
This represents the simplest layout of the Element Control software. It provides controls for only Inputs and Outputs. All other
settings are disabled or hidden:
All Analog Input Channels and Monitor output controls are represented in the Essentials bar. The small buttons below the Gain
controls correspond to the Input Settings 48V, G, SL, and ⌀. The buttons under the Output Volume controls correspond to the
output buttons M, D and Σ.
For convenience, the Essentials bar can be converted to a vertical orientation via the Orientation Button. In this way, the
Essentials bar can be placed next to your DAW software for easy access.
30